Random good picture Not show

1. Grain growth is favourable for increasing magnetic flux density.

2. In center column of core , magnetic flux density is reduced by counteraction.

3. At the same gap width, the magnetic flux density increases with an increase in stirring current, but decreases with the stirring frequency increasing.

4. In calculating the magnetic flux density B between two blocks of parallel block capacitors, there are two common solutions,[http://sentencedict.com/magnetic flux density.html] one of which is not correct.

5. The magnetic flux density is uniform near the center of coil, therefore, the meniscus level in mold should locates between the coil center and the top of mold in casting operation.

6. Relationship between MRF' s yield stress and magnetic flux density, the shear stress and magnetic flux density and shears tress and shear rate were investigated.

7. Using the proposed model, the relation between the magnetic flux density in the air of the giant magnetostrictive force sensor and the value of force applied on the magnetostrictive rod is calculated.

8. At the same current and frequency, the magnetic flux density increases as the stirring gap width decreases gradually.

9. It is a necessary to predict a magnetic flux density surrounding a current-carrying conductor in design of EMC and current sensor.

10. Magnetic Field Intensity, Magnetic Flux Density, Coercive Force, Vertical Axis Wind Turbine, NdFeB Rare-Earth Permanent Magnet.

11. The mechanism of influence of the magnetic flux density on migratory behavior was discussed.

12. The magnetic flux density distribution of flat spiral coil simulation by impulsive current usually used in electromagnetic metal forming is researched.

13. Calculations and experiments are carried out on both magnetic flux density and eddy current loss of the non-magnetic steel plate and of the coil in this model.

14. The increase in magnetic flux density no longer has effect on particle aggregation after particles are saturatedly magnetized.

15. The methods to reduce transformer noise by reducing magnetic flux density and optimizing structure design are discussed under saving transformer material cost.

16. The maximum electromagnetic force is in direct proportion to the square of magnetic flux density and in inverse proportion to the current frequency.

17. The average flow rate along the channel axes of the molten channel is in direct proportion to the magnetic flux density and in inverse proportion to the square root of the density of the molten metal.

18. The research showed that the control result of electromagnetic brake was related to casting speed, mould angle and magnetic flux density.

19. The results show that the dynamic behavior of the novel damper is easily controlled by adjusting the magnetic flux density in the radial clearance.

20. By numerical analysis, a series of curves are given to describe the magnetic flux density distribution character of the flat spiral coil.

21. Considering the inconvenience of using the magnetic vector potential as state variable, magnetic flux density is used as the state variable in the design optimization.

22. An empirical formula describing the dependence of the power of hysteresis loss on frequency, magnetic flux density and temperature was derived.

23. Fe-based nanocrystalline core transformer inverter which has a high saturation magnetic flux density, high efficiency, small excitation power, low loss, good temperature stability.

24. The bifurcation process of cementite flake is changed by magnetic field. The cementite flakes in pearlite grains tend to be parallel with the increase of magnetic flux density.

25. The magnetic fluid sealing pressure is mainly related to the magnetic flux density of the magnetic gap, and also related to the structure.

26. The finite element analysis of the magnetic field for a MR valve of the damper was done via ANSYS package, and the magnetic flux density of MR valve was obtained.

27. The vector plot of 3D magnetic flux and the surface plot for the radial component of magnetic flux density were obtained, which could show the feature of the MLF near defect expressly.